Attaching The Microphone (Provided); Attaching The Microphone (Optional) - JVC GY-DV5100 Instructions Manual

3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS

3-4 Attaching the Microphone (Provided)

1.3.
Microphone cable Cable clamp
VF

3-5 Attaching the Microphone (Optional)

2.4.
3.
5.
FRONT MIC INPUT Microphone cable
4.
2.
5.
7.
KA-A50U
Microphone holder
1.
MV-P615U/MV-P618U
6.
Connect the provided microphone to the viewfinder. The
provided microphone is a phantom microphone.
1.
Loosen the stopper screw on the viewfinder.
2.
Attach the microphone to the attachment guide on the
viewfinder as illustrated.
3.
Confirm that there is no gap between the microphone and
the viewfinder, and then tighten the stopper screw.
4.
Tighten the screw on the microphone. The microphone
should be firmly attached.
5.
Connect the cable from the microphone to the FRONT MIC
IN connector on the camera.
6.
Set the FRONT MIC +48V switch on the right side of the
camera to ON.
7.
Secure the microphone cable using the cable clamp
provided on the front side of the microphone holder.
MEMO:
When attaching the viewfinder for use with the left eye, the
provided microphone cannot be attached. In this case, use
the optional microphone holder KA-A50U and microphones
MV-P615U/618U (phantom microphone).
With the optional KA-A50U microphone holder, the optional
microphones MV-P615U (phantom microphone) and MV-P618U
(phantom microphone) can be used.
<Attaching the Microphone Using KA-A50U>
1.
Secure the microphone holder with 2 screws.
2.
Turn the small knob located on the outer side of the
microphone holder counterclockwise to loosen it, and loosen
the large knob located on the inner side in the same way.
Rotate the large knob fully counterclockwise to open the
holder.
3.
Attach the microphone to the microphone holder at the
designated place so that the microphone does not interfere
with the cassette cover.
4.
Set the microphone holder so that the height is level, and
tighten the inside and outside knobs to secure the
microphone.
5.
Connect the microphone cable to the FRONT MIC IN
connector.
● When the microphone is connected to REAR AUDIO IN
connector on the rear panel, set the CH-1 or CH-2 AUDIO
input selector switch to REAR.
6.
Secure the microphone cable using the cable clamp located
on the front side of the microphone holder.
7.
Make sure to perform the correct settings for use of a
phantom microphone.
☞ See "
!
FRONT MIC +48V switch" on page 16.
CAUTION:
● When the light mounted on the camera is used at the
same time, if the microphone in use has a long sound
collecting section, the microphone's shadow may appear
in the image.
E-33