Table of Contents
Advertisement
Adjusting the sound level
To adjust the sound level:
1.
Repeat steps 1-2 above.
2.
Press
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences.
The following settings do not affect the projection settings, operation, or
performance.
•
Menu display time in the SYSTEM SETUP: Advanced > Menu Settings
menu sets the length of time the OSD will remain active after your last key
press. The time length ranges from 5 to 30 seconds in 5-second increments.
Use
/
•
Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu
sets the OSD position in five locations. Use
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for
the OSD menus. Use
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo
screen to be displayed during projector start-up. Use
Shutting down the projector
1.
Press
I
message displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
I
POWER indicator light flashes orange,
the projection lamp shuts down, and the
fans will continue to run for approximately
90 seconds to cool down the projector.
3.
The POWER indicator light is a steady
orange and fans stop.
4.
Disconnect the power cord from the wall
socket if the projector will not be used in an
extended period of time.
CAUTION
•
To protect the lamp, the projector will not respond to any commands during the cooling
process.
•
To shorten the cooling time, you can also activate the Quick Cooling function. See
Cooling" on page 40
•
Do not unplug the power cord before the projector shutdown sequence is complete or
during the 90-second cooling down process.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press
start the projector after the fans stop and the POWER indicator light turns orange.
to highlight Volume and press
to select a suitable time frame.
/
I
POWER and a confirmation
I
POWER a second time. The
for details.
/
/
to select your language.
to select a desired sound level.
to select a preferred position.
/
to select a screen.
POWER again to
I
I
Operation
"Quick
35
Advertisement
Table of Contents
