Table of Contents
Advertisement
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not
suitable for your need. You can use one of the picture modes (except the User 1/
User 2) as a starting point and customize the settings.
1.
Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2.
Go to the PICTURE > Preset Mode menu.
3.
Press
/
4.
Press
This function is only available when User 1, or User 2 mode is selected up in the Preset Mode
sub-menu item.
5.
Press
/
6.
Press
/
. See
7.
When all settings have been done, highlight Save Settings and press MODE/
ENTER to store the settings.
8.
The confirmation message 'Setting Saved' displays.
Using Wall Color
In the situation where you are projecting onto a colored surface such as a painted
wall which may not be white, the Wall Color feature can help correct the projected
picture's color to prevent possible color difference between the source and
projected pictures.
To use this function, go to the DISPLAY > Wall Color menu and press
select a color which is the closest to the color of the projection surface. There are
several precalibrated colors to choose from: Light Yellow, Pink, Light Green,
Blue, and Blackboard.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions
available when User 1 or User 2 mode is selected. You can make adjustments to
these functions based on your needs.
Adjusting Brightness
Highlight Brightness in the PICTURE menu and adjust the values by pressing
on the projector or remote control.
The higher the value, the brighter the image. And
lower the setting, darker the image. Adjust this
control so the black areas of the image appear just
as black and that detail in the dark areas is visible.
Adjusting Contrast
Highlight Contrast in the PICTURE menu and adjust the values by pressing
on the projector or remote control.
The higher the value, the greater the contrast. Use
this to set the peak white level after you have
previously adjusted the Brightness setting to suit
your selected input and viewing environment.
to select User 1 to User 2.
to highlight Reference Mode.
to select a picture mode that is closest to your need.
to select a sub-menu item to be changed and adjust the value with
"Fine-tuning the image quality in user modes"
below for details.
/
to
+50
+30
/
0
+30
Operation
/
+70
-30
29
Advertisement
Table of Contents
