Konica Minolta PagePro 1380 MF Service Manual page 151

Code Status
Too many
xxxx41
FTT
Too many
xxxx42
CRP
xxxx43 T2 Time Out
DCN
xxxx44
received
DTC
xxxx45
Received
Remote not
xxxx46 capable
for Polling
Comm. Error (at Phase-C)
xxxx50 T2 Time Out
Image Data
xxxx51
not ready
Phase-C
xxxx52
Time Out
Comm. Error (at Phase-D)
xxxx60 Retry Out
xxxx61 T2 Time Out
Description
• Received Failure to Train
(FTT) from other side
even with the minimum
speed of 2400 bps.
• Received Command
Repeat (CRP) from other
side more than 3 times
after sending DCS (TCF).
• Did not receive DCS from
other side within 6 sec-
onds after sending DIS.
• Received Disconnect
command (DCN) from
other side at Phase B.
• Received Digital Transmit
Command (DTC) from
other side.
• Other side was not in Poll-
ing TX when Polling RX.
• Did not receive PIX/ECM
from other side within 6
seconds after sending
CFR.
• Scanner/Encode delayed
in Manual transmission.
• Cannot be ready for
Image data within 10 sec-
onds after starting Image
transmission.
• Did not receive any
response from other side
after three retries of
(PPS-) Q command.
• Did not receive (PPS-) Q
Command from other side
within 6 seconds after
sending PIX/ECM signal
at receiving.
T-41
Cause
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Retry TX
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Retry TX
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Retry TX
• Failure in • Check the status
remote machine of the remote
machine
• Failure in • Check the status
remote machine of the remote
machine
• Error in opera- • Check the Poll-
tion on remote ing TX setting
side of the remote
• The fax number machine
is wrong • Check the fax
number
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Request retry
TX
• ADF Jam • Clear the ADF
Jam and retry
TX
• System failure • Replace the
Controller/
Image Control
Board (PWB-I)
• Line failure • Retry TX
• Failure in • Check the status
remote machine of the remote
• Line failure machine
• Retry TX
Action