Microwave Oven Hood Combo Service Manual — LIT 4317216
REMOVING THE SYNCHRONOUS MOTOR
WARNING
Personal Injury Hazard
Disconnect from the electrical supply be-
fore servicing the unit. Failure to do so
could result in death or electrical shock.
1.
Disconnect the electrical supply to the
microwave oven.
2.
Remove the vent grille and the base plate
from the microwave oven (see the illus-
tration on page 2-3).
DISTRIBUTION BLADE
BOTTOM PANEL
OF OVEN
INSET 2
SYNCHRONOUS
MOTOR
MOUNTING
SCREWS
3.
Open the oven door and pry up the bottom
panel and remove it from the oven (see
inset 1).
4.
Lift the turntable off the motor shaft and
remove it.
5.
From the bottom of the oven, pull the
connectors off the synchronous motor ter-
minals.
6.
Remove the two motor mounting screws
from the synchronous motor and remove
the motor (see inset 2).
7.
Install the new motor and then reassemble
the microwave oven.
NOTE "TOP"
MOTOR
SHAFT
INSET 1
PRY UP EDGE OF
BOTTOM PANEL WITH
A PUTTY KNIFE
BOTTOM
OF OVEN
YELLOW WIRE
BROWN WIRE
2-25
Original 03/97
Page 2-25