Table of Contents
Advertisement
SC230 Paper OM 062206.fm Page 34 Friday, July 21, 2006 7:39 PM
Scanning Preprogrammed Races
Before You Get To The Track
Each driver's team has several different frequencies they
can use during a race. These frequencies can change
depending on local interference sources or other
frequency issues. Your scanner is preprogrammed with
all of the drivers and their possible frequencies that were
known when it was manufactured.
Before you leave for the track, check the Internet to see if
there are any frequency updates available for your race.
You can save time at the track by setting up as much as
possible before you leave.
When You Get To The Track
When you arrive at the race, get a list of the actual
frequencies in use that race day. These are normally
available for sale on the way into the facility. This list will
show the actual frequency being used by each driver that
day, as well as some other useful frequency information.
Then, follow the steps in the sections below to adjust the
scanner settings.
Selecting Driver Frequencies
Follow these steps to select the appropriate frequency for
each driver.
1. Press 0 in Scan mode, rotate the scroll control to
select the race, then press E.
2. Press CAR, enter the driver's number, then press E.
Or press CAR, press E, rotate the scroll control to
select the driver, then press E.
3. Rotate the scroll control to select the driver's
frequency. If the driver's frequency is not listed, select
NEW Frequency then enter the correct frequency.
4. Press Hold to set the selection.
Holding on a Car
Follow these steps to hold on a car within the currently-
selected racing system.
Basic Operation
34
Advertisement
Table of Contents
