Table of Contents
Advertisement
SC230 Paper OM 062206.fm Page 37 Friday, July 21, 2006 7:39 PM
Locking/Unlocking Channels
Follow these steps to lock out a channel so that it does
not scan even if its system and channel group are
selected.
1. While holding down
select the system where the channel is stored.
2. Release
then press Hold within 2 seconds to
Func
hold on the system.
3. Rotate the scroll control to select the channel you
want to lock or unlock.
4. Press L/O to lock or unlock the channel.
You can also lock out an active channel by pressing L/O
while the scanner is stopped on the channel.
Temporarily Holding On a System
To temporarily hold on a system, press and hold
To hold on a different system, continue to hold
rotate the scroll control to select the system. Normal
scanning resumes 2 seconds after you release
Holding On a Channel
To hold on a channel, press Hold while the channel is
active. To select a different channel, rotate the scroll
control. If you scroll past the beginning or end of the
current system, the scanner selects channels in the
previous or next system. To resume scanning, press Scan.
Note: You can select any channel (locked or unlocked).
, rotate the scroll control to
Func
Basic Operation
37
.
Func
and
Func
.
Func
Advertisement
Table of Contents
