Connection Of External Equipment; General Wiring - Furuno SC-50S Operator's Manual

1.6

Connection of External Equipment

1.6.1

General wiring

All external equipment are terminated on the MAIN Board inside the processor
unit. Turn off the power and unfasten four screws to remove the cover. Connect
wiring from external equipment referring to the interconnection diagram. Use the
terminal opener supplied to open terminal blocks, referring to the instructions
below.
DATA OUT1-DATA OUT5 (AD-10/IEC 61162-1/2, 4-pole)
Note: Roll, pitch analog out voltage [V] = 0.0785 x θ (deg.) + 3.5 (θ = roll, pitch angle)
Output example
Roll or pitch angle
0 [deg]
5 [deg]
10 [deg]
20 [deg]
From top: Analog Roll, Analog Pitch, 2-pole. See Note.
LOG/ALARM (Contact signal, 6-pole)
DATA IN (AD-10/IEC 61162-1/2, 5-pole)
BEACON EXT (RTCM SC-104, 3-pole)
DATA OUT6 (AD-10, 4-pole)
Processor unit, cover opened
Analog out voltage
3.5 [V]
3.8925 [V]
4.285 [V]
5.07 [V]
1. INSTALLATION
Recommended Cables*:
Power cable:
IEC 61162 equipment: TTYCS-1
AD-10 equipment:
* Or equivalent
How to insert cores in terminal blocks
Opener
1. Insert opener.
2. Press opener.
3. Insert core.
4. Release opener.
Power Cable
DPYC-1.5
TTYCS-1Q
1-21