Advertisement
CONFIGURATION
SECTIONS
Table of Contents
Overview
The Adapter uses 128-bit AES encryption to block access from
the outside. By default, the protection is enabled. However, it is
recommended that you change the default network password with the
"Encryption" button located on the units.
Powerline AV+ Networking Adapter
1
Encryption
Reset
2
Changing the Network Password
1. With both Adapters plugged into the wall, press the "Encryption"
button on both units for 10 seconds. The password on
these Adapters has now been changed to a random value.
2. Next, press the "Encryption" button on one unit for more
than 0.5 seconds, but less than three seconds.
3. Within two minutes, press the "Encryption" button on the second
unit for more than 0.5 seconds, but less than three seconds.
4. The new network password has now been saved to
the second unit. The password will not be lost, even
if the Adapters are unplugged from the wall.
5
3
4
Advertisement
