Advertisement
HOW TO USE YOUR HEATER
FEET ASSEMBLING
Fit the feet to the convector as follows:
Insert the foot ensuring that the bigger hole A on the foot coincides with the screw mounted on the
base of the convector (see figure 1); then screw in the remaining three screws (see figure 2) which
are supplied.
Note: the convector mut be used only with the feet correctly fitted!
A
fig. 1
fig. 2
BE CAREFUL
Operate the heater in upright position only.
Any other position could create hazardous situation!
LOCATION
Place heater on floor beneath coldest window in the room or any desired location.
Used in this way, your heater will minimize the effect of cold drafts.
The heater must not be placed immediately below an outlet.
CONNECTION
This appliance must be grounded.
This appliance is equipped with a cord having a grounding wire with a grounding plug.
The radiator must be connected to a properly installed and grounded AC 110-120 V household
outlet in perfect working conditions.
Improper use of the grounding plug can result in a risk of electric shock. The use of an extension
cord is not recomanded, but if it is necessary to use one, use only a three-wire extension cord that
has a 3-blade grounding plug, and a 3-slot receptacle that will accept the plug on the appliance.
The minimum recommanded size of the extension cord is 14 AWG, rated not less than 1875 Watts.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where
the heater plug is fitted in.
TURNING THE HEATER ON
Turn the thermostat knob clockwise to the highest setting and position the switch in the MIN position
(minimum power) or MAX position (maximum power) the indicator light will go on, indicating that
unit is operating.
HOW TO SWITCH THE APPLIANCE OFF
To switch the appliance OFF position the switch in the "OFF" position.
ADJUSTING THE THERMOSTAT
When the room has reached the desired temperature, turn the thermostat knob slowly in an counter-
clockwise direction until you hear a click and the appliance turns off (indicator light off). The
thermostat will now keep the temperature in the room constant, turning the heater on and off as
appropriate.
MAINTENANCE AND SERVICE
Disconnect plug and allow the heater to cool. Wipe with a soft damp cloth, do not use detergents
and abrasives.
Should the heater not be in use over a certain length of time, keep it in a dry place. This appliance
has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater yourself. Call nearest Service Center
Visit www.delonghi.com for a completelist of Service Centers (U.S. Only).
4
Advertisement
