Table of Contents
Advertisement
SAFETY DEVICE
A safety device switches the heater off in the event of overheating. To restart the heater,
call the nearest service center. Note: when the safety device intervenes, the heater doesn't
heat but the display works.
4. MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the radiator to cool. Wipe radiator
with a soft damp cloth, do not use detergents and abrasives. Should the radiator not be in use
over a certain length of time, wind the cable round the holder and store it in a dry place. This
appliance has been built to give many years of trouble free service. In case of malfunction or
doubt, do not try to repair the heater by yourself: it may result in a fire hazard or electric
shock. Call the nearest Service Center (see attached list of Service Centers) or call customer
support at 1-800-322-3848.
TROUBLESHOOTING
PROBLEM
The appliance doesn't work
The remote control doesn't
work
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. lf this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not approved by the party responsible for compliance could void user's authority
to operate the equipment.
CAUSE
• Be sure it is plugged in and
that the electrical outlet is
working.
• Check for any obstruction.
• The thermostat may be set too
low.
• Check the batteries have been
correctly positioned.
• The batteries are discharged.
SOLUTION
• Plug into the mains.
• Remove the obstruction and
let the appliance cool down.
If the appliance doesn't work
please contact the nearest
service center.
• Set the thermostat in a
higher position.
• Position the batteries correc-
tly.
• Replace the batteries.
7
Advertisement
Table of Contents
