Prepare For Installation; Installation Procedure - Fisher & Paykel E522BRX2 Manual

Joiner Kit
For Fisher & Paykel Models: C270, E249T, E240B, E210, E381T, E372B, N388, E388,
C450, E450, E402B, E411T, E415H, E413T, E406B, E440T, E442B, E521T & E522B

PREPARE FOR INSTALLATION

Step1.
1. Check that the internal cupboard cavity dimensions are
correct for the type of installation you require.
2.
Unpack the refrigerator and freezer cabinets from their
separate delivery cartons (see individual cartons for
unpacking procedures).
3. Ensure the floor and/or the cupboards are protected from
damage during the unpacking and assembly of the
cabinets.
4. Check the refrigerator and freezer doors are hinged on the
desired side.
5. Check that the Kit is complete (refer to Joiner Kit parts list
on page 1).
Note: due to the size of the refrigerator cabinets, it is essential
that any assembly of the kit be undertaken with a minimum of
two able-bodied persons.

INSTALLATION PROCEDURE

Step 2.
If your refrigerator has a unit compartment cover at the back,
remove using a Phillips type screw driver (USA market only).
This will be re-attached later.
Looking at the back of the two products, locate the Rear
Bracket onto the rear bottom left hand edge of the right hand
side product. Care must be taken to line up the top edge of the
Rear Bracket with the bottom edge of the white back panel.
Secure the Rear Bracket with 3 of the screws (Type A, self
tapping, silver). These 3 screws are mounted from the side.
Please note there are no pre-drilled holes for these screws
which hold the rear bracket onto the side of the cabinet.
Step 3.
Locate the left hand side cabinet's bottom right rear wall within
the open "U" section in the rear bracket. Ensure that the cabinet
sits firmly with the rear bracket.
Introduction Date: October 2007
Right hand side cabinet
Step 2
Pt No.819265 INSTRUCTION KIT JOINER RF
Do not secure with screws (see page 4).
Left hand side cabinet
Step 4.
Locate the front adjustable feet. One can be found at each of
the cabinet's front lower corners.
Adjust the two feet by turning either clockwise or anti-clockwise
until the two cabinets are level.
Step 5.
Remove the three screw hole caps from the top surface of each
of the cabinets with a small flat bladed screwdriver by gently
prising them loose. The caps can be found on the front edge of
the top surface of the cabinets, opposite side to the hinge.
Ensure that the top panel is not scratched or deformed during
this process. The total of six screw hole caps are not required
to be used with the kit.
Right hand side cabinet
Step 3
Step 4
Step 5
4