Table of Contents
Advertisement
BCO65 GB
3-07-2002
on the warming plate, the coffee will be man-
tained at an ideal drinking temperature.
HOW TO PREPARE ESPRESSO COFFEE
1. Unscrew the boiler cap by turning it in a anti-
clockwise direction.
2. Using the water level indicators printed on the
small carafe (fig. 9) according to the number of
cups of espresso coffee that are required (see
the chart page 9).
3. Pour the water into the steam boiler (fig. 10).
4. Replace the boiler cap by turning firmly in a
clockwise direction.
5. Insert the filter for espresso coffee into the filter
holder (fig. 11).
6. Fill the filter with the ground coffee, using the
measures indicated in the chart page 9 and
pack it evenly in the filter (fig. 12). It is impor-
tant to use high quality ground coffee with a
medium grind in order to avoid the blocking of
the filter during the brewing.
excess coffee from around the edges of the fil-
ter (fig. 13).
7. To attach the filter holder to the appliance,
position it under the hot water spout with the
handle towards the left (fig 14). Push upwards,
and at the same time, turn the handle as far
right as possible. It does not matter if the filter
holder is not centrally aligned with the
machine. It is important that the filter holder is
firmly attached to the appliance.
8. Place the small carafe under the filter holder,
the carafe lid will slot under the filter holder.
9. Position the "Vario System" selector knob
according to the type of espresso coffee
desired:
"LIGHT" for a weaker coffee and
"STRONG" for a stronger tasting brew (fig.
16).
10. Make sure that the steam release knob is
closed. (eg to close turn in a clockwise direc-
tion until tightened)
11. Push the ON/OFF switch for espresso/cap-
puccino. The ON indicator light for espres-
so/cappuccino will turn on (fig. 17).
12. After approximately two minutes, the espresso
coffee will begin to flow out (fig. 18).
ATTENTION:
detach the filter holder while the machine is
brewing coffee.
13:41
Pagina 7
Remove any
to avoid spraying, do not
13. When the coffee no longer flows out from the
filter holder, push the espresso/cappuccino
ON/OFF switch to turn off the steam boiler
(fig. 17). The coffee can then be served into
cups.
14. To remove the used coffee in the filter, detach
the filter holder, from the machine hold the fil-
ter in place with the special lever incorporated
on the handle and let the coffee fall out by
turning the filter holder upside down and
knocking gently (fig. 20).
NOTE:
Before removing the filter holder, it is important to
eliminate all of the residual steam from inside the
steam boiler. Allow the steam to blow out com-
pletely by rotating the steam release knob in an
anti-clockwise direction (fig 19).
NOTE:
For safety reasons, when the steam boiler is hot, it
is not possible to remove the steam boiler cap; this
is a safety feature. If for any reason it is necessary
to remove it, it is important always to release the
steam in the steam boiler by turning the steam
release knob.
HOW TO USE THE TWO CUP ATTACHMENT
The attachment must be used every time coffee is
dispensed directly into a cup. To mount it, simply
insert the attachment into the lower part of the fil-
ter holder (fig 21)
HOW TO PREPARE CAPPUCCINO
• Prepare the espresso coffee as described in the
paragraph "How to prepare espresso coffee"
from points 1 to 12; using the quantity of
water required to obtain 2 cappuccinos as
indicated in the chart page 9. Note that the
quantity of water required for making cappuc-
cinos is greater that the amount necessary for
making espresso coffee:
used for producing steam for frothing the milk.
• Brew the coffee into the small espresso carafe
as paragraph "How to prepare espresso cof-
fee". When the coffee reaches level 2 on the
side of the small espresso carafe (fig. 22), turn
the Vario System selector to "cappuccino" (fig.
16). If you allow too much coffee to come
the extra water is
7
Hide quick links:
Advertisement
Table of Contents
