Using Serveraid Manager; Configuring The Controller - IBM 6223 User Manual

2. From the list of ready drives, type C to create an array.
3. When asked to select the RAID type, select RAID-1.
4. From the list of ready drives, select the two drives that you want to group into
5. Select Create new RAID-1.
6. Type an identifier for the array.
7. Select Yes to create the array.
8. Press Esc to exit the utility.
9. Restart the computer.
Viewing the configuration: You can use the SCSISelect Utility program to view
information about the integrated SCSI controller. From the list of available arrays,
select an array and press Enter. Press Esc to exit the utility.

Using ServeRAID Manager

Use the ServeRAID Manager program to:
v Configure arrays
v View your RAID configuration and associated devices
v Monitor operation of your RAID controllers
To perform some tasks, you can run ServeRAID Manager as an installed program.
However, to configure the SCSI controller and perform an initial RAID configuration
on your computer, you must run ServeRAID Manager in a Startable-CD mode, as
described in the instructions in this section. If you install a RAID adapter in your
computer, use the configuration method described in the instructions that come with
the adapter to view or change SCSI settings for attached devices.
See the ServeRAID documentation on the IBM ServeRAID Support CD or
additional information about RAID technology and instructions for using ServeRAID
Manager to configure your SCSI controller. Additional information about ServeRAID
Manager is also available from the Help menu. For information about a specific
object in the ServeRAID Manager tree, select the object and click Actions → Hints
and tips.

Configuring the controller

By running ServeRAID Manager in Startable CD mode, you can configure the
controller before you install your operating system. The information in this section
assumes that you are running ServeRAID Manager in Startable CD mode.
To run the ServeRAID Manager program in startable-CD mode, turn on the
computer; then, insert the IBM ServeRAID Support CD into the CD-ROM drive. If
the ServeRAID Manager program detects an unconfigured controller and ready
drives, the program automatically starts the Configuration wizard.
In the Configuration wizard, you can select express configuration or custom
configuration. Express configuration automatically configures the controller by
grouping the first two physical drives in the ServeRAID Manager tree into an array
and creating a RAID level-1 logical drive. If you select custom configuration, you
can select the two physical drives that you want to group into an array and create a
hot-spare drive.
the array.
Chapter 3. Configuring the computer
29