Cleaning The Milk Container; Cleaning The Touch Screen; Descaling - DeLonghi ESAM 6700 Instruction Manual

pressing it forcefully from
the bottom and top as
shown in the figure.
7. Once inserted, make
sure the two red but-
tons have snapped
out.
8. Replace the drip tray
and grounds contai-
ner.
9. Close the service
door.

Cleaning the milk container

Clean the milk container each time you prepare
milk as described below:
1. Turn the milk con-
tainer lid clockwi-
se then remove it.
2. Remove the milk
spout and intake
tube.
3. Remove the poin-
ter by pulling it
outwards.
4. Wash all the com-
ponents tho-
roughly with hot
water and mild
washing-up liquid.
All components
can be washed in a
dishwasher, placing
them in the top
basket of the dish-
washer.
Make sure there are no milk residues left insi-
de the holes and the groove on the fine end of
the pointer.
5. Check that the intake tube and spout are not
clogged with milk residues.
6. Replace the pointer, milk spout and intake
tube.
7. Replace the lid on the milk container, turning
it anticlockwise to hook it in place.

Cleaning the touch screen

1. If the machine is on, turn off by pressing the
button (fig. 5) to avoid starting it acci-
dentally during cleaning.
2. Clean the control panel with a damp cloth. Do
not use solvents, aggressive detergents
Spout
Milk intake
tube
Groove
Pointer
Hole
Hole
39
and/or sharp objects as they could damage
the surface of the panel.

DESCALING

Descale the machine when the message "DESCA-
LE!" flashes on the icon display.
Important! Descaler contains acids which
may irritate the skin and eyes. It is vital to adhere to
the manufacturer's safety warnings given on the
descaler pack and the warnings relating to the pro-
cedure to follow in the event of contact with the skin
and eyes.
N.B.! Use De'Longhi descaler only. Under
no circumstances should you use sulphamic or
acetic based descalers. Their use invalidates the
guarantee. Failure to descale the appliance as
described above also invalidates the guarantee.
1. Turn the machine on.
2. Enter the programming menu by pressing the
P icon.
3. Press the or icon until "Descaling" is
displayed.
4. Select by pressing the OK icon.
"Descaling Confirm?" is displayed. Press OK
to activate the function.
5. The message " Add descaler. Confirm?" is dis-
played.
6. Before confirming, empty the water tank
(A13).
Pour the descaler diluted with water (respec-
ting the proportions indicated on the descaler
bottle) into the water tank.
Place an empty container with a minimum
capacity of 1.5 litres under the hot water
spout (1.5 l).
Important! Danger of burns Hot water con-
taining descaler flows out of the hot water spout.
Avoid contact with splashes of water.
7. Confirm by pressing the OK icon.
8. The message "Descaling Underway..." is dis-
played. The descaling programme starts and
the descaler liquid comes out of the water
spout.
The descale programme automatically performs a
series of rinses and pauses to remove limescale
deposits from inside the machine.
GB