I Setting Tag Channels; I Starting A Scan - Icom IC-M33 Instruction Manual

I Setting TAG channels

For more efficient scanning, set the desired channels as TAG
channels or clear the TAG setting from unwanted channels.
Channels that are not tagged will be skipped during scanning.
TAG channels can be assigned to each channel group
(U.S.A., International and ATIS) independently.
q Push and hold [CH] for 1 sec. several times to select the
desired channel group, if desired.
w Select the desired channel to be set as a TAG channel.
e Push and hold [TAG] (FAV) for 1 sec. to set the displayed
channel as a TAG channel.
• " " appears in the function display.
r To cancel the TAG channel setting, push and hold [TAG]
(FAV) for 1 sec.
• " " disappears.
✔ Clearing (or setting) all tagged channels
While pushing and holding [TAG] (FAV), turn power ON to
clear all TAG channels in the selected channel group.
• Repeat above procedure to set all channels as TAG channels
(when no TAG channel has been set.)
[Example]: Starting a normal scan.
Scan starts
Push

I Starting a scan

Set the priority scan function, scan resume timer and auto
scan function in advance, using set mode. (p. 18)
q Push and hold [CH] for 1 sec. several times to select the
desired channel group, if desired.
w Push [SCAN] to start priority or normal scan.
• "SCAN" blinks in the function display.
• "16" appears on the sub channel readout during priority scan.
• When a signal is received, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to the scan re-
sume timer setting. (Channel 16 is still monitored during priority
scan.)
• Push [Y]/[Z] to check which channels have been set as TAG
channels, change the scanning direction or resume the scan
manually.
e To stop the scan, push [SCAN].
• "SCAN" disappears.
• Pushing [PTT], [16], [CH] or [FAV] also stops the scan.
When a signal is received
SCAN OPERATION
Push
to stop the scan
5
5
15