Restoring Bios To Default Factory Settings - HP Z800 Hardware Setup Manual

BIOS Menu
Power
Advanced

Restoring BIOS to Default Factory Settings

If necessary, perform the following procedure to restore the BIOS settings to factory defaults.
To restore default factory BIOS settings:
1 Press F10 while booting the workstation to enter the system BIOS.
2 In the File menu, select Default setup, then Restore Factory Settings as Default.
3 Press F10 to accept the changes.
4 In the File menu, select Apply Defaults and Exit, then press F10 to confirm.
The factory system defaults are restored.
5 When the workstation reboots, press F10 again to re-enter the BIOS, and configure the recommended
Autodesk settings.
42 | Chapter 7 Configuring the Workstation BIOS
Submenu
Boot Order
OS Power Management
Hardware Power Management
Processors
Chipset/Memory
Device Options
Slot 1 PCIe2 x8(4)
Slot 3 PCIe2 x8(4)
Slot 4 PCIe2 x16(8)
Slot 6 PCI32
Item
Optical Drive
USB Device
Hard Drive
Runtime Power Management
Idle Power Saving
MWAIT Aware OS
ACPI S3 Hard Disk Reset
SATA Power Management
Intel Turbo Boost Technology
Hyper-Threading
Memory Node Interleave
NUMA Split Mode
S5 Wake on LAN
Internal Speaker
NIC PXE Option ROM Download
Option ROM Download
Option ROM Download
Option ROM Download
Option ROM Download
Value
<hard drive model>
Integrated SATA
Disable
Normal
Disable
Disable
Disable
Disable
Enable
Enable
Disable
Disable
Disable
Disable
Disable
Disable
Disable
Disable