Husqvarna 324R X-Series Operator's Manual page 21

Choke: Set the choke control in the choke position.
Primer bulb: Press the air purge repeatedly until fuel begins
to fill the bulb. The bulb need not be completely filled.
Warm engine
Ignition: Set the stop switch to the start position.
Choke: Put the choke in working position.
Primer bulb: Press the air purge repeatedly until fuel begins
to fill the bulb. The bulb need not be completely filled.
For throttle handles with a start throttle
lock:
Set the throttle to the start position by first pressing the
throttle lockout and the throttle trigger, then pressing the
start throttle button (A). Then release the throttle lockout and
the throttle trigger, followed by the start throttle button. The
throttle function is now activated. To return the engine to idle,
press the throttle lockout and throttle trigger again.
STARTING AND STOPPING
Starting
WARNING! When the engine is started with
!
the choke in either the choke or start
throttle positions the cutting attachment
will start to rotate immediately.
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until you
feel some resistance (the starter pawls grip), now quickly
and powerfully pull the cord. Never wrap the starter cord
around your hand
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and apply
full throttle; the throttle will automatically disengage from the
start setting.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Stopping
Stop the engine by switching off the ignition.
–
English 21