Table of Contents
Advertisement
Manual accuracy
We are proud to offer this manual with your new
machine! We've made every effort to be exact
with the instructions, specifications, drawings, and
photographs of the machine we used when writ-
ing this manual. however, sometimes errors do
happen and we apologize for them.
Also, owing to our policy of continuous improve-
ment, your machine may not exactly match
the manual. if you find this to be the case, and
the difference between the manual and machine
leaves you in doubt, immediately call our techni-
cal support for updates or clarification.
For your convenience, we always keep current
grizzly manuals and most updates available on
our website at www.grizzly.com. Any updates to
your machine will be reflected in these documents
as soon as they are complete. Visit our site often
to check for the latest updates!
contact Info
We stand behind our machines. if you have any
service questions, parts requests or general ques-
tions about the machine, please call or write us at
the location listed below.
grizzly industrial, inc.
1203 lycoming Mall Circle
Muncy, pA 17756
phone: (570) 546-9663
Fax: (800) 438-5901
E-Mail: techsupport@grizzly.com
if you have any comments regarding this manual,
please write to us at the address below:
grizzly industrial, inc.
/
technical documentation Manager
C
o
p.o. Box 2069
Bellingham, WA 98227-2069
Email: manuals@grizzly.com
-2-
INTRODucTION
functional Overview
the tenoning jig is designed to work with your
table saw to make a tenon, such as shown in
figure 1, which will be part of a mortise and tenon
joint.
figure 1. Example of a completed basic tenon.
With the tenoning jig mounted into the miter slot of
the table saw, the workpiece is clamped upright to
the jig in various configurations so that the tenon
cheek cuts can be made. then, the jig is removed
and the workpiece is laid flat on the table saw to
make the shoulder cuts.
Table Saw
Requirements
the h7583 tenoning Jig is designed to work with
most table saws. use the table saw requirements
listed below to verify that your table saw will work
with the tenoning jig.
table saw Miter slot ......... standard
distance from Miter slot Center to Blade:
Minimum ........................................................3
Maximum .......................................................6
⁄
" w/t-slot
3
4
⁄
"
3
4
⁄
"
3
4
h7583 tenoning Jig
Advertisement
Table of Contents
