MSI G41M-P25 User Manual page 27

MS-7592
fail to retain data. This item applies only when synchronous DRAM is installed
in the system.
tRAS
When the DRAM Timing Mode sets to [Manual], the field is adjustable. This set-
ting determines the time RAS takes to read from and write to a memory cell.
tRTP
When the DRAM Timing Mode sets to [Manual], the field is adjustable. Time
interval between a read and a precharge command.
tRFC
When the DRAM Timing Mode sets to [Manual], the field is adjustable. This set-
ting determines the time RFC takes to read from and write to a memory cell.
tWR
When the DRAM Timing Mode is set to [Manual], the field is adjustable. It speci-
fies the amount of delay (in clock cycles) that must elapse after the completion
of a valid write operation, before an active bank can be precharged. This delay
is required to guarantee that data in the write buffers can be written to the
memory cells before precharge occurs.
tRRD
When the DRAM Timing Mode sets to [Manual], the field is adjustable. Speci-
fies the active-to-active delay of different banks.
tWTR
When the DRAM Timing Mode is set to [Manual], the field is adjustable. This
item controls the Write Data In to Read Command Delay memory timing. This
constitutes the minimum number of clock cycles that must occur between the
last valid write operation and the next read command to the same internal bank
of the DDR device.
FSB/DRAM Ratio
This item will allow you to adjust the ratio of FSB to memory.
Adjusted DRAM Frequency (MHz)
It shows the adjusted memory frequency. Read-only.
Adjust PCI-E Frequency (MHz)
This item allows you to adjust the PCI-E frequency.
Auto Disable DRAM/PCI Frequency
When set to [Enabled], the system will remove (turn off) clocks from empty DIMM
and PCI slots to minimize the electromagnetic interference (EMI).
DRAM Voltage (V), NB Voltage (V), CPU VTT (V), CPU Voltage (V)
These items are used to adjust the voltage of CPU, Memory and chipset.
Spread Spectrum
When the motherboard's clock generator pulses, the extreme values (spikes) of
the pulses create EMI (Electromagnetic Interference). The Spread Spectrum func-
tion reduces the EMI generated by modulating the pulses so that the spikes of
the pulses are reduced to flatter curves. If you do not have any EMI problem,
leave the setting at Disabled for optimal system stability and performance. But if
2