Table of Contents
Advertisement
Minute Minder
To set a countdown. A signal sounds after the time has elapsed.
This function does not affect the functioning of the oven.
Duration
To set how long the oven is to be in use.
End
To set when the oven is to switch off again.
Time of day
To set, change or check the time
(See also section "Before Using for the First Time").
Heat+Hold
The Heat+Hold function keeps your prepared dish warm for 30 minutes, after the baking
or roasting process is completed.
How to use the clock functions
• After a clock function has been selected, the corresponding function light flashes for
about 5 seconds. During this period, the desired times can be set or modified using
the
or
button.
• When the desired time has been set, the corresponding function light continues to
flash for approx. 5 seconds, then remains illuminated. The set time begins to run.
• With Countdown the oven must also be switched on in order to set the clock function.
• By pressing
and
Checking the time set or remaining
Press the Selection button repeatedly, until the appropriate clock function flashes and
the time set or remaining is displayed.
Using residual heat with the Duration and End clock functions
When the Duration and End clock functions are used, the oven switches the heating el-
ements off, when 90% of the time set or calculated has elapsed. The residual heat
present is used to continue the cooking process until the time set has elapsed
(3 to 20 mins.).
at the same time, the time set can be reset.
19
Using the Oven
Advertisement
Table of Contents
