Engine Operating Panel - MULTIQUIP Whisperwatt DCA25SSIU3 Operation And Parts Manual

The defi nitions below describe the controls and functions
of the Engine Operating Panel (Figure 5).
1. Panel Light - Normally used in dark places or at
night. When activated, panel will luminate. When the
generator is not in use, turn the panel light switch to
the OFF position.
2. Panel Light Switch- When activated, will turn on control
panel light.
3. Oil Pressure Alarm Lamp - Indicates that the oil
pressure is too low or high. This condition will cause the
engine to shut down.
4. Water Temperature Alarm Lamp - Indicates that the
engine water temperature is too high. This condition will
cause the engine to shut down.
5. Fuel Filter Alarm Lamp - Indicates that the water level
in the fuel fi lter has risen. Drain the water in the fuel fi lter
strainer when this condition occurs.
6. Pre-heat Lamp - Indicates (ON) when the engine
is ready for starting during cold weather operating
conditiions.
DCA25SSIU3 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (12/20/10) — PAGE 19
Figure 5. Engine Operating Panel
7. Ignition Switch – Three position switch, stop, run and
8. Tachometer – Indicates engine speed in RPM's for 60
9. Fuel Gauge – Indicates amount of diesel fuel available.
10. Charging Ammeter Gauge – Indicates the current being
11. Water Temperature Gauge – During normal operation
12. Oil Pressure Gauge – Normal operation should be

ENGINE OPERATING PANEL

start. Insert ignition key to start and stop engine.
Hz operation. This meter should indicate 1800 RPM's
when the rated load is applied. In addition a built in hour
meter will record the number of operational hours that
the generator has been in use.
supplied by the engine's alternator which provides current
for generator's control circuits and battery charging
system.
this gauge should read between 165°~203° F. (74°~95° C).
approximately 28~71 psi (193~490 kPa). When starting
the generator the oil pressure may read a bit higher, but
after the engine warms up the oil pressure should return
to normal.