Table of Contents
Advertisement
D-4
Please set the first boot sequence as "floppy" in BIOS and boot off the floppy disk.
7. Flash the BIOS in pure DOS mode. After successfully booting off of the floppy, execute the flash
utility according to these instructions show below:
A:\awdflash se6_sw.bin /cc /py /sn /r
We strongly recommend you use the above parameters following "awdflash" to flash your BIOS. DO
NOT just type "awdflash se6_sw.bin" without the above parameters following the .bin file. You only
can use the "awdflash.exe" attached in NV7m product CD-ROM, DO NOT USE the others Award
flash program to flash your NV7m BIOS.
The Award flash utility can't be completed under a Windows
®
2000, Windows
XP, Windows
You should check which BIOS file is to be used with your motherboard, don't flash with the wrong
BIOS file. Otherwise, you may cause system malfunctions.
During the updating, the progress will be measured by white blocks. The last four blue blocks of the
flash update process represent the "BIOS boot block". The BIOS boot block is used to prevent the
BIOS from becoming corrupt during programming. It should not be programmed every time. If this
"BIOS boot block" remains intact when the BIOS becomes corrupt during programming, then you
can boot from a bootable floppy next time you boot your computer. This allows you to flash your
BIOS again without the need for technical support from the dealer.
NV7m Motherboard
Note
Note
®
ME environment, you must be in a pure DOS environment.
Note
®
®
95/98 or Windows
Appendix D
®
NT, Windows
Advertisement
Table of Contents
