Abit KG7-RAID User Manual page 44

3-16
" DataStrobe SlewRate (Fall):
Four options are available: Slowest ) Slow ) Fast ) Fastest. The default setting is Fastest. This
item is used to directly program the fall time in all AGP data strobes.
DDR MA Configuration:
Two options are available: Auto or Manual. The default setting is Auto. When you choose "Manual" the
following four items will available for you to set. It is recommended this field be set to Auto in order to
avoid any errors in your system.
" MA RiseEdge SlewRate:
Eight options are available: 0 ) 1 ) 2 ) 3 ) 4 ) 5 ) 6 ) 7. The default setting is 5. This item
can control the rising edge slew rate of the MA (Memory Address).
" MA FallEdge SlewRate:
Eight options are available: 0 ) 1 ) 2 ) 3 ) 4 ) 5 ) 6 ) 7. The default setting is 5. This item
can control the falling edge slew rate of the MA (Memory Address).
" MA P Drive Strength:
Four options are available: 0 ) 1 ) 2 ) 3. The default setting is 3. This item can control the P
transistor drive strength of the MA (Memory Address).
" MA N Drive Strength:
Four options are available: 0 ) 1 ) 2 ) 3. The default setting is 2. This item can control the N
transistor drive strength of the MA (Memory Address).
DDR CMD Configuration:
Two options are available: Auto or Manual. The default setting is Auto. When you choose "Manual" the
following four items will available for you to set. It is recommended this field be set at Auto in order to
avoid any errors in your system.
" CMD RiseEdge SlewRate (Command Rising Edge Slew Rate):
Eight options are available: 0 ) 1 ) 2 ) 3 ) 4 ) 5 ) 6 ) 7. The default setting is 5. This item
can control the rising edge slew rate of the RASB#, CASB#, WEB#, and CKEB# pins.
" CMD FallEdge SlewRate (Command Falling Edge Slew Rate):
Eight options are available: 0 ) 1 ) 2 ) 3 ) 4 ) 5 ) 6 ) 7. The default setting is 5. This item
can control the falling edge slew rate of the RASB#, CASB#, WEB#, and CKEB# pins.
" CMD P Drive Strength (Command P Driver Strength):
Four options are available: 0 ) 1 ) 2 ) 3. The default setting is 3. The item can control the P
transistor driver strength of the RASB#, CASB#, WEB#, and CKEB# pins.
" CMD N Drive Strength (Command N Driver Strength):
Four options are available: 0 ) 1 ) 2 ) 3. The default setting is 2. The item can control the N
transistor driver strength of the RASB#, CASB#, WEB#, and CKEB# pins.
KG7-Lite/KG7/KG7-RAID
Chapter 3