Abit KG7-RAID User Manual page 33

Introducing the BIOS
Solution in case of booting problem due to invalid clock setup:
Normally, if the CPU clock setup is wrong, you will not be able to boot. In this case, turn the system off
then on again. The CPU will automatically use its standard parameters to boot. You can then enter the
BIOS Setup again and set up the CPU clock. If you can't enter the BIOS setup, you must try turning the
system on a few times (3~4 times) or press "INSERT" key when turning on and the system will
automatically use its standard parameters to boot. You can then enter BIOS SETUP again and set up the
new parameters.
When you change your CPU:
This motherboard has been designed in such a way that you can turn the system on after having inserted a
CPU in the socket without having to configure any jumpers or DIP switches. But if you change your CPU,
normally you just have to turn off the power supply, change the CPU and then, set up the CPU parameters
through SOFT MENU
type), we offer you two methods to successfully complete the CPU change operation.
Method 1: Setup up the CPU for the lowest speed for its brand. Turn the power supply off and change
the CPU. Then turn the system on again, and set up the CPU parameters through SOFT
™
MENU
Method 2: Since you have to open the computer case when you change the CPU, it could be a good idea
to use the CCMOS jumper to erase the parameters of the original CPU and to enter BIOS
Setup to set up CPU parameters again.
After setting up the parameters and leaving the BIOS SETUP, and having verified that the system can
be booted, do not press the Reset button or turn off the power supply. Otherwise the BIOS will not
read correctly, the parameters will fail and you must enter SOFT MENU
parameters all over again.
Power Supply Controller:
This option allows you to switch between Default and User Define voltages.
! Default:
The system will detect the CPU type and select the proper voltage automatically. When
it is enabled, the option "Vcore Voltage" will show the current voltage setting that is
defined by the CPU and this will not be changeable. We recommend using this CPU
default setting and not changing it unless the current CPU type and voltage setting can
not be detected or is not correct.
! User Define: This option lets the user select the voltage manually. You can change values of the
"Vcore Voltage", "I/O Voltage" and "DDR Vcc Voltage" option lists by using the
arrow up and arrow down keys.
™
III. However, if the new CPU is slower than the old one (and is same brand and
III.
Attention
™
III again to set up the
User's Manual
3-5