Installation; Setting Up - Geemarc CL320 User Manual

INSTALLATION

Setting Up

Connect the handset to one end of the curly cord. The connector at
the end of the curly cord plugs into the socket on the left hand side of
the CL320 unit.
Open the battery compartment (push the small clip backwards and
then upwards). Insert 4 good quality alkaline batteries (AA size, 1.5V
type, not supplied) into the battery compartment located on the base
of the telephone. Replace the battery cover. If the batteries are
running low, the battery icon will appear on the LCD display.
Ensure that the telephone is not connected to the telephone line
socket and/or mains power connection when the batteries are being
inserted or replaced.
Note : Do not use rechargeable batteries. Do not put batteries into
the household rubbish, pay attention to battery regulations regarding
battery disposal.
Connect the line cord to the socket located at rear of telephone then
connect the plug into the wall socket *.
Connect the power supply to the socket located at rear of the
telephone then plug into a 13amp wall socket. Please choose a
socket near your telephone to enable you to unplug the mains power
quickly in case of a problem.
(*) Classified "hazardous voltage" according to EN60950 standard
(**) Classified TNV-3 according to EN60950 standard.
8