Table of Contents
Advertisement
GENERAL SETTINGS
1 - HOW TO CONNECT THE PHONE AND SET THE BATTERIES
1 - Plug the adaptor in the power wall socket and the power plug in the
base socket (*).
2 - Connect the line cord plug to the base socket (**).
3 - Connect the line cord to the PTT socket.
4 - Insert the batteries with the correct polarity into the batteries compartment
and replace the battery cover.
5 - Place the handset on the base unit then a short beep will be heard
and the battery symbol will flash on the display, except if the batteries are
totally empty.
NOTE:
Do not expose the base to electric equipment like TV, radio, monitors,
sunlight, heat or other phones...to avoid any disturbances of your phone.
(*) Classified "hazardous voltage" according to EN60950 standard.
(**) Classified TNV-3 according to EN60950 standard.
2 - CHARGING THE BATTERIES
The phone is supplied with NiMH rechargeable batteries. In standby mode, batteries
are fully charged around 170 hours and talk time is around 8 hours. The battery
charge icon
will flash as long as the phone is being charged and will stop when
the charging process is complete. The phone has an automatic charging control to
avoid excessive charging.
IMPORTANT:
Batteries must be charged during 24 hours before using the
phone for the first time.
Battery charge icon:
The handset display shows
signal is heard. If the phone does not have enough power or is not completly
recharged, it switches itself off automatically until it is returned to the base unit.
when the batteries are flat and when a warning
10
Advertisement
Table of Contents
