GE Monogram ZBD6605 Owner's Manual page 23

Questions? PROBLEM
Use this
Suds in the tub (cont.)
problem
solver
Dishes and flatware
not clean
Water leaks through
door handle
POSSIBLE CAUSE
Too much rinse agent used • Remove any spilled rinse aid.
Improper rack loading
Filter or spray arms dirty
Inlet water temperature
is below 120°F
Air gap is clogged
Water pressure is
temporarily low
Opening door during
cycle without pausing
machine first
WHAT TO DO
For all other models:
• Pump out water by closing the door until
it locks into place.
• Press the NORMAL WASH button, then
press start.
• Wait for one minute, then press and hold
down the START/CANCEL button for
three seconds. Repeat if necessary.
• Reduce rinse aid setting.
• For soft water, rinse aid may be unnecessary.
• Make sure large dishware does not block
the detergent dispenser or the wash arm.
• Assure silverware is not blocking spray arm.
• Clean filters and spray arms according to
instructions on page 20.
• Run tap until water is hot, prior to starting
Chef's Washer cycle.
• Raise the water heater temperature to 120°F.
• Depending on model, use WATER TEMP
HIGH or WATER TEMP SANI option if
suitable for dish load.
• Clean the air gap.
• Turn on a faucet. Is water coming out more
slowly than usual? If so, wait until pressure
is normal before using your Chef's Washer.
• Pause the cycle before opening the door.
Follow instructions for interrupting the
cycle for your specific model.
23