Ethernet Connection To One Computer - THOMSON TCM470 User Manual

Chapter 1: Connections and Setup

Ethernet Connection to One Computer

Make the connections to the modem in the following sequence:
1. Connect one end of the coaxial cable to the cable connection in the wall, and the other end to the connector on
the modem labeled "CABLE."
2. Insert the plug from the AC power supply into the power AC jack on the cable modem and the two-prong plug
into the AC outlet.
Note: Use only the power supply that accompanied this unit. Using other adapters may damage the unit.
3. Connect one end of the Ethernet cable (straight-wired, see below) to the Ethernet port on the back of your
computer, and the other end to the ETHERNET port on the cable modem's back panel.
Make sure that the Ethernet cable is straight-wired (not "null" or crossover-wired). However, you will need a
crossover-type cable if you are connecting the modem to a hub, or a hub within a port switch that provides the
same function.
Fig. 2
9