Step 1A, Move Refrigerator Indoors (Zfsb26) - GE Monogram ZFSB25D SS Installation Instructions Manual

STEP 1A MODEL ZFSB26
MOVE REFRIGERATOR INDOORS
IMPORTANT:
into the installation location require a 36" min. opening.
If the opening is less than 36", the top cap and doors
must be removed.
NOTE: Skip this step if door removal is not required.
See instructions on next page, "To Move The
Refrigerator Indoors."
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit is
moved to the installation location.
E
Wire Harness
Installation Instructions
Door and passageways
B
Hinge Screws
D
Water Line Coupler
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best
to remove one door at a time.
A. Remove 2 screws and springs on top of the
refrigerator, one on each side. Push the top cap
forward and lift up from the rear.
B. Remove 2 screws holding the top filler strip, lift off.
C. Open both doors. Remove the 2 toekick screws and
pull forward to remove.
D. Disconnect the water line coupler by pushing against
the collar on the left side. Disconnect wire harness.
E. Remove 2 screws holding top hinge to the case.
Carefully lift off door.
Follow the same procedure to remove the fresh food
door.
A
6
C
Toekick Screw