Step 1A, Move Refrigerator Indoors (Zfsb23) - GE ZFSB23DSS Installation Instructions Manual

STEP 1A MODEL ZFSB23
MOVE REFRIGERATOR INDOORS
IMPORTANT:
into the installation location must allow the full depth
of the refrigerator to pass through. ZFSB23 requires
a 31" min. opening. When the opening is less than these
minimum widths, the top cap and doors must be removed.
NOTE: Skip this step if door removal is not required.
See instructions on next page, "To Move The Refrigerator
Indoors."
NOTE: To prevent damage, leave inside
packaging, door spacer and outside
protective wrap in place until the unit
is moved to the installation location.
E
Wire Harness
Installation Instructions
Doors and passageways
B
Hinge Screws
D
Water Line Coupler
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best
to remove one door at a time.
A. Remove 2 screws and springs on top of the refrigerator,
one on each side. Push the top cap forward and lift up
from the rear.
B. Remove 2 screws holding the top filler strip, lift off.
C. Open both doors. Remove the 2 toekick screws and pull
forward to remove.
D. Disconnect the water line coupler by pushing against
the collar on the left side. Disconnect wire harness.
E. Remove 2 screws holding top hinge to the case.
Carefully lift off door.
Follow the same procedure to remove the fresh food door.
A
6
C
Toekick Screw