Cancelling A Programme; Opening The Door - Electrolux EWS 31054 EDU User Manual

Table of Contents

Advertisement

14 www.electrolux.com
9.6 Interrupting a programme
and changing the options
You can change only some options be-
fore they operate.
1.
Press
2.
Change the options.
3.
Press
tinues.

9.7 Cancelling a programme

1.
Turn the programme knob to
cancel the programme and to deacti-
vate the appliance.
2.
Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
The appliance does not drain the
water.

9.8 Opening the door

While a programme or the delay start op-
erates, the appliance door is locked and
the display shows the indicator
CAUTION!
If the temperature and level of the
water in the drum are too high,
you cannot open the door.
Open the appliance door when the
delay start operates:
1.
Press
2.
Wait until the door lock indicator
goes off.
3.
You can open the door.
4.
Close the door and press
The delay start continues to operate.
Open the appliance door when the
programme operates:
1.
Turn the programme knob to
deactivate the appliance.
2.
Wait for some minutes and then open
the appliance door.
3.
Close the appliance door.
4.
Set the programme again.
9.9 At the end of the
programme
• The appliance stops automatically.
. The indicator flashes.
again. The programme con-
to pause the appliance.
again.
• The acoustic signal operates (if it is acti-
vated).
• In the display
• The indicator
• The door lock indicator
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent the mil-
dew and odours.
• Close the water tap.
• Turn the programme knob to
activate the appliance.
to
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door lock indicator
door stays locked.
– You must drain the water to open the
door.
To drain the water:
1.
If necessary, decrease the spin
speed. if you set
.
only drains.
2.
Press
water and spins.
3.
When the programme is completed
and the door lock indicator
goes off, you can open the door.
4.
Turn the programme knob to
deactivate the appliance.
The appliance drains and spins
automatically after approximately
18 hours (except for Wool pro-
gramme).
9.10 Stand-by
Some minutes after the end of the wash-
to
ing programme, if you do not deactivate
the appliance, the energy saving status
activates.
The energy saving status decreases the
energy consumption when the appliance
is on the stand by.
• All indicators go off.
• The indicator of the
• Press one of the options to deactivate
the energy saving status.
comes on.
goes off.
goes off.
to de-
is on. The
, the appliance
. The appliance drains the
flashes slowly
to

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ews 31254 edu

Table of Contents