Station Relocation; Account Code Entry - NEC Univerge DT310 User Manual

Intercom calls to extensions with Selectable
Note:
Display Messaging set will receive a DND
signal and receive the display message on
their telephone's display instead of ringing the
display.
Note: To allow calls to ring through and have the
message displayed on the calling extension's
display, cancel DND by pressing the DND key
+ 0 (DND key (Code 03).
To cancel a message:
1. Press the Speaker key.
2. Dial 798 (Code 18+).
3. Press Speaker to hang up.
2-14 THU

STATION RELOCATION

To exchange two terminals:
1. Pick up the handset or press the Speaker key.
2. Dial the Extension Data Swap Service Code – not
assigned at default.
3. Dial the Extension Data Swap Password – not
assigned at default.
4. Dial the extension to be swapped with or relocated
to.
4:20PM
CANCEL
5. When successfully completed, a confirmation tone
will be heard and the display will show "completed".
6. Press the Speaker key twice.

ACCOUNT CODE ENTRY

To enter an Account Code any time while on a trunk
call:
The outside caller cannot hear the Account Code digits
you enter. You can use this procedure if your system
has Optional Account Codes enabled. You may also be
able to use this procedure for incoming calls.
1. Dial *.
-OR-
Press your Account Code key
(Code 50).
2. Dial your Account Code (1~16 digits, using 0~9
and #).
LINE 001
Enter Account Code
Conf
Note: If Account Codes are hidden, each digit you
dial shows as a "*" character on the
telephone's display.
3. Dial *.
-OR-
Press your Account Code key (Code 50).
39
Rpt Sav Trf