Digital Displays; Cooking Zone Safety Cut-Out - AEG Electrolux EHS 8675 P Installation And Operating Instructions Manual

Digital Displays

The four display fields that are assigned to the four
cooking zones display:
– _, after being switched on and when the safety
function causes an automatic cut-out,
– 0 when a cooking zone is selected,
– 1 to 9, depending on the selected heat setting,
– a during automatic warm up,
– h when there is residual heat,
– f when there is a fault.
1
Cooking Zone Safety
Cut-out
If one of the cooking zones is not switched off after a
certain time or if the heat setting is not changed, the
corresponding cooking zone switches itself off auto-
matically.
h appears in the ring display for all rings that are
switched on, and _ after they have cooled down.
The rings are switched off at:
• Heat setting 1 - 2
• Heat setting 3 - 4
• Heat setting 5
• Heat setting 6 - 9
3
If one or more cooking zones switch off before
the times indicated see section "What to do
if ...".
Cancelling the Safety Cut-out
To cancel the activated safety cut-out the appliance
must be switched off and then on again using the
ON/OFF sensor field. After this the cooking zones
are again ready for use.
Switching Off for Other Reasons
Liquid that boils over onto the control panel causes
all cooking zones to switch off immediately.
If you place a wet cloth on the control panel it has
the same effect. In both cases the appliance has to
be switched on again using the mains switch
removing the liquid or cloth.
8
after 6 hours
after 5 hours
after 4 hours
after 1.5 hours
after