Troubleshooting; Problem Solver - GE Advantium ZSC1201 Owner's Manual

Troubleshooting
Advantium Oven
Questions?
Use this
problem
solver
Problem Possible Causes What To Do/Explanation
LIGHTS
Light during a
speedcook cycle
dims and cycles on
and off, even at full
power levels
This is normal.
Power level has been
automatically reduced
because the oven is hot.
• This is normal. The oven senses the
heat level and adjusts automatically.
Light visible around
the door and outer
case while
speedcooking
This is normal.
• When the oven is on, light may
be visible around the door and
outer case.
FAN
Fan continues to run The oven is cooling.
after cooking stops
• The fan will automatically shut off
when the internal parts of the oven
have cooled.
Oven vent emits
warm air while
oven is on
This is normal.
Fan comes on This is normal.
automatically when
using the microwave
COOKING
The oven makes
unusual sounds
while cooking
Clicks and fans blowing
are normal. The relay
board is turning the
components on and off.
• These sounds are normal.
Smoke comes out
of the oven when
I open the door
Food is high in fat
content. Aerosol spray
used on the pans.
• Smoke is normal when cooking
high-fat foods.
Food is not fully
cooked or browned
at the end of a
program
Programmed times
may not match the size
or amount of food you
are cooking.
Increase or decrease time for
doneness or adjust the upper or
lower lamps for browning and cooking
doneness.
SENSOR ERROR
displayed along with
an oven signal
Food amount or type
placed in the oven does
not match the program
that was set.
• Press the CLEAR/OFF pad. Set the
oven program to match the food or
liquid to be cooked or heated.
Steam was not sensed by
the oven because plastic
wrap was not vented, a lid
too tight was on the dish
or a liquid was covered.
o Vent plastic wrap, use a looser lid
or uncover liquids when cooking or
heating.
39