Abit BH6 User Manual page 68

B-6
BIOS Setup:
If all your HDDs are new, you can use the IDE HDD Auto Detection
option in the CMOS to auto detect the parameters of all your drives.
You don't need to set any hard disk parameter.
If one or several of your HDDs are old, and if you don't know their
parameters, and you want to reconfigure your drives, you can still use
the IDE HDD Auto Detection option in the CMOS to auto detect the
drives parameters.
If one or several of your HDD are old, and if you don't want to erase
the data stored in your drives, you will have to remember the
parameters (Type, Cylinders, Heads, Sectors, Mode) of the drive(s)
you don't want to erase. After you have used the IDE HDD Auto
Detection option in the CMOS, enter the Standard CMOS Setup
Menu to change the settings of the related hard disk drive.
Software use:
The basic step in using a hard disk drive is to make a HDD Low Level
Format, than run FDISK, and than FORMAT the drive. Most of present
HDD have already been subjected to low level format at the factory, so
you probably can skip this operation.
Boot with a bootable floppy disk, then enter FDISK
$Using FDISK: (DOS command)
This command is found in the DOS disks.
FDISK is a tool used to organize and to partition the hard disk. The
hard disk must have been partitioned before use. You can create one
unique partition on the hard disk, or create several partition and use a
different Operating System on each partition. Just don't forget that
you have to specify an Active partition, otherwise your hard disk will
not be bootable. For further information about FDISK, refer to the
FDISK section in the DOS user's manual.
After you have partitioned the hard disk with FDISK, the system will
Appendix B