Using your TELUS Satellite TV service
Setting up your remote control using device codes scan
If the code for your device isn't listed in the tables starting on page 71 , use this procedure to scan the remote control's memory
for the device code .
INSTRUCTIONS
1
Turn the device on .
2
Press and hold the appropriate mode button until
all the other mode buttons light up, and then let go
of the button . The mode button should flash .
3
For AUX mode only . Press
for a second VCR or DVD player , or
A/V receiver . Then press
4
Press
.
5
Press
or
turns off .
6
Press
.
7
Turn the device back on and try some other
buttons to make sure they work .
8
If necessary, repeat this procedure until you've tried
all the codes .
ADDITIONAL INFORMATION
Use the device' s front panel buttons or its remote
control .
For example, hold
mode buttons light . When you let go,
for a second TV,
This step is for programming which kind of device
for an
should be programmed in AUX mode . If you're not
.
programming in AUX mode, skip to step 4 .
This puts your remote in the scan mode .
As you press
repeatedly until the device
in the memory to see if it can turn off your device .
When the device turns off, you have found a code
that might work .
Note:
rapidly 8 times when you've scanned all the codes
for that device .
The mode button flashes 3 times if you have entered
the code correctly . This stores the code you found .
Sometimes
If using limited mode, try
for a TV until all of the other
will flash .
, the remote tries each code
The mode button for the device will flash
works when other buttons don't .
or
.
28