Improving Receiver Control - TELUS Satellite TV HD PVR User Manual

Using your TELUS Satellite TV service

Improving receiver control

1
System Info
Press on the receiver's front panel . The System Information will display onscreen and show the remote address . If you want
to change the address for remote control, write down the primary remote address:
2
Press and hold for about 3 seconds, until all of the mode buttons light up, and then let go .
3
Use the number buttons on your remote to enter any number between 1 and 16 other than the number you wrote down in step 1 .
4
Press . If you entered the address correctly
5
Press twice to open the
the same as the one you entered in step 3 . If it isn't, the remote won't be able to control the receiver .
6
Press to close the System Information screen .
Checking the remote control address
You can see what address is programmed on the remote control by completing these steps:
1
Close any menus and press and hold
2
Press twice . will flash the same number of times as the address number (3 flashes means address 3) .
Confirming remote control operation
Complete the following steps to make sure the remote operates the receiver:
1
Make sure the remote is in SAT mode .
2
System Info
Press on the receiver's front panel to display the System Information screen on the TV .
3
Press . The primary remote address in the System Information screen changes to match the address preset in your remote control .
4
Press to turn receiver on/off .
will flash 3 times . Write down the number you entered:
System Information
screen . Make sure the remote address you see on the System Information screen is
for 3 seconds until all of the mode buttons light up, then let go .
.
.
23