Output Terminals - MULTIQUIP Power DCA10SPX3 Operation And Parts Manual

Output Terminal Panel Available Voltages
The DCA10SPX3 is a single phase generator only. It is
able to supply both 120 volt and 240 volt.
120V Hard Wire Hookup
The output terminal panel, when suppling single phase 120
volts, will provide two circuits available at 41.7 amps with
any two wires plus the ground. (See Figure 10 below.)
Figure 10. Hard Wire Hook-up
DCA-10SPX3 A.C. GENERATOR — PARTS & OPERATION MANUAL — REV. #2 (01/17/11) — PAGE 27
for 120 Volt
DCA10SP3X OUTPUT TERMINAL
Maximum Amps
The DCA-10SPX3 can provide 41.7 amps at 120 or 240
volts. Do not exceed the maximum amps!
240V Hard Wire Hookup
The output terminal panel, when suppling single phase 240
volts, will provide one circuit available at 41.7 amps with
two wires plus the ground. (See Figure 11 below.)
Figure 11. Hard Wire Hook-up
for 240 Volt
When using plural single phase
voltages, make sure to balance
the load on each of the single
phase legs.
NOTE