4D68 Engine (E - Mitsubishi 4D68 Workshop Manual

MD998781
Plug
6EN0563
E Mitsubishi Motors Corporation
4D68 ENGINE (E - W) -
AE" CRANKSHAFT BOLT LOOSENING
DEN0743
AF" CRANKSHAFT SPROCKET REMOVAL
MD998778
DEN0744
AG" OIL PUMP SPROCKET REMOVAL
(1) Before loosening the oil pump sprocket nut (flange nut),
Screwdriver
6EN0564
AH" TIMING BELT "B" REMOVAL
(1) Using chalk, etc., mark an arrow on the back of the timing
DEN0745
Dec. 1996
Timing Belt
remove the timing belt and then the plug at the left side
of the cylinder block and insert a Phillips screwdriver [shank
diameter 8 mm] through the plug hole to keep the left
counterbalance shaft in position.
Caution
D If the nut is loosened without removing the timing
belt, the force produced by loosening the nut will
be borne by the belt and can cause damage to
the belt cogs.
belt to indicate the direction of rotation. This is to ensure
correct installation of the belt in case it is reused.
NOTE
(1) Water or oil on the belt shortens its life drastically,
so the removed timing belt, sprocket, and tensioner
must be free from oil and water. Do not immerse parts
in cleaning solvent.
(2) If there is oil or water on any part, check the front
case oil seals, camshaft oil seal and water pump for
leaks.
PWEE9609
11A-4-3