Xerox DocuColor 7000AP User Manual page 61

Problem
Fault Code 112-130 Paper is jammed
Jam indicated in between the
finisher. Exit Module and the
finisher sensors.
Fault Code 112-110 Paper jammed in the
finisher and the Exit
Module during a
purge of sheets to the
Top Tray.
Fault Code 052-310 Communication
problem
Fault Code 052-321 Connection problem
Fault Code 052-320 Unexpected
connection
Fault Code 052-312 Communication
problem
Ready Indicator No power
does not illuminate
Poor Stacking: Mixed sizes of paper
High paper curl
Mechanical
obstruction
Paper Jams: Use Top Tray
High paper curl
Do c u Co lo r 70 0 0A P /8 0 00 A P U s er G u i de
Cause
• Open the finisher door.
• If no jammed paper is visible in the area indicated,
open the Exit Module door and clear any jammed
paper. Close the Exit Module door.
• Open and close the finisher door.
• If the fault persists, undock the finisher and clear the
jammed paper between the Exit Module and the
finisher. Refer to the Note below this table for
information on how to undock the finisher.
• Clear the jammed paper from the finisher.
• Clear the jammed paper from the Exit Module.
• Open and close the finisher door.
• Resume job.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and power
on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and power
on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and power
on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and power
on.
• Check the power cord connected to the power source.
• Check that the main switch is on.
• Run separate jobs and empty stacker.
• Adjust digital press decurler.
• Flip paper in digital press paper tray(s).
• Rotate paper in the digital press paper tray(s).
• Check for obstruction in the stacker stapler paper path.
• Ensure that all transports and baffles are properly
seated.
• Deselect offset or restart job to the Top Tray.
• Adjust digital press decurler.
• Flip paper in digital press paper tray(s).
• Rotate paper in the digital press paper tray(s).
• Switch to heavier paper.
10 . B as i c Tr ou b le s h oo ti n g
Solution
10-7