Installing The System Card And The Battery Pack - Emerson 375 User Manual

2-4
INSTALLING
THE SYSTEM
CARD AND
THE BATTERY
PACK
Figure 2-1. Back side of the 375 Field Communicator
Battery pack
retaining screws
1. Place the 375 Field Communicator face down on a
level, secure surface; see Figure 2-1.
2. Lock the stand into the hanger position. To pivot past
the stand position, squeeze the stand together near
the hinge.
Main unit
label
Battery pack
3. With the battery pack removed, place the System
Card, with the card contacts facing up, on the main
unit System Card guide ribs (located directly below
the battery pack connector). Insert the System Card
until it is firmly in place.
4. With the main unit still face down, ensure the tops of
the two battery pack retaining screws are flush with
the top of the battery pack.
5. Install the battery pack by aligning the sides of the
battery pack and main unit and carefully sliding the
battery pack forward until it is secure. If the battery
pack and main unit are not properly aligned, the
connector pins can be damaged.
6. Tighten the two battery pack retaining screws until
they are secure (do not overtighten). The tops of the
screws should now be close to flush with the stand
groove.
Learning the Basics
Stand
assembly
IS label
(KL Option)
System Card