Emerson 375 User Manual page 73

Fieldbus Functionality
Figure 4-7. Device Block menu and Mode Screen
Change Modes
Whenever you need to change the parameters or
properties of a block, you need to change the mode. A
warning message may appear whenever the mode of
any block is included in a list of parameter changes to be
sent to a device.
To change the block mode:
1. From the Block list screen, double-tap a block.
2. Tap the MODE button.
3. Remove the checkmark next to the current mode by
tapping the checkbox next to it. An asterisk (*) symbol
will appear next to Block Mode: Target to indicate a
change has been made to the Target mode. Only the
permitted modes will be displayed. If the mode
checkboxes are read only, the block may have been
set to allow only one mode.
4. Tap the checkbox next to a mode to select it as the
new Target mode. A checkmark appears.
5. Tap OK.
6. When the warning message appears, thoroughly read
it and tap YES to send the change to the device, or
tap NO to cancel the operation. A Mode Change
screen showing the Target mode and Actual mode will
be displayed until the Actual mode is updated. Tap
CLOSE to close the Mode Change screen.
4-13