Starting Up And Shutting Down; Starting The 375 Field Communicator - Emerson 375 User Manual

Learning the Basics
STARTING UP
AND
SHUTTING
DOWN
Starting the
375 Field
Communicator
Prior to using the 375 Field Communicator without the
charger/power supply, fully charge the battery pack. A
full charge is indicated by a solid green light on the
charger/power supply. Charging may take up to two
hours, but the 375 Field Communicator may be used
while charging. Before operating the 375 Field
Communicator, ensure:
• The 375 Field Communicator is not damaged.
• The battery pack is fully seated.
• All screws are sufficiently tightened.
• An Expansion Module (EM) or Expansion Port Plug is
in place.
• The communication terminal recess is free of dirt and
debris.
Press and hold the on/off/stand by key until the
multifunction LED flashes to indicate the unit is powering
(approximately two seconds). See Figure 2-2 for the
location of the on/off/stand by key.
During start-up, the 375 Field Communicator will
automatically install any software upgrades available on
the System Card. Once the upgrade is complete, the
375 Main Menu will be displayed. After starting the 375
Field Communicator, you can:
• Launch the HART or F
applications (if licensed)
• Configure/view settings
• Enter Listen For PC mode
• Launch the ScratchPad application
fieldbus
OUNDATION
2-5