Assembly Instructions - Kawai Concert Performer CP119 Quick Start Manual

2) ASSEMBLY INSTRUCTIONS

Ensure that this section is read thoroughly before attempting to assemble the CP119 digital piano, and
Caution
that two or more people work on unit assembly.
When moving the CP119 digital piano, ensure that hands are not caught in the unit, and that the piano
is not dropped on an individual's feet.
Before attempting to assemble the CP119 digital piano, ensure that all parts are included.
A Phillips-head screwdriver will also be required to assemble the unit (not included).
PARTS PROVIDED
Main Unit (A).................................................1 pc.
Side Panel (B)............................................. 2 pcs.
Pedal Board (C) ............................................1 pc.
Back Board (D) .............................................1 pc.
End Panel (E).............................................. 2 pcs.
Music Rack (F)..............................................1 pc.
Screw Long (G)........................................... 4 pcs.
Screw Black (H) .......................................... 4 pcs.
Screw Silver (I)............................................ 4 pcs.
Long Bolt (J) ............................................... 4 pcs.
Short Bolt (K) .............................................. 4 pcs.
Adjuster (L) ...................................................1 pc.
Headphone hook set
Headphone hook (M)...............................1 pc.
Tapping screw (N).................................. 2 pcs.
ASSEMBLY SEQUENCE
1. Insert the Adjuster (M) approximately 1 cm into the bottom of
the Pedal Board (C).
Untie and extend the connection cord from the Pedal Board.
Loosely fasten the left and right Side Panels (B) to the Pedal
Board (C) using a single short screw (I) for each side. After
ensuring that the correct Side Panels are used for the left and
right side, and that the pedal cable is not caught between the
assembled parts, securely fasten the Side Panels to the Pedal
Board using an additional four short screws (I) on each side.
2. Fasten the Back Panel (D) to the left and right Side Panels (B)
using a single long screw (G) on either side.
Then, fasten the Back Panel to the Pedal Board using four
medium screws (H).
Screw (G) Screw (H)
ø4 30 ø4 20
Long Bolt (J) Short Bolt (K)
M6 25 M6
I
Pedal cable
G
G
Page
119
Screw (I)
ø4 16
Adjuster (L)
25
M
G
G
D
9