Configuring Static Routes; Figure 156 Static Route; Table 112 Static Route - ZyXEL Communications P-662H-61 User Manual

Chapter 18 Static Route

18.2 Configuring Static Routes

Use this screen to configure static routes on the ZyXEL Device. Click Advanced > Static
Route to open the Static Route screen.

Figure 156 Static Route

The following table describes the labels in this screen.

Table 112 Static Route

LABEL
#
Active
Name
Destination
Gateway
Subnet Mask
Modify
Apply
Cancel
274
DESCRIPTION
This is the number of an individual static route.
This field shows whether this static route is active (Yes) or not (No).
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
This is the subnet mask of the destination network.
Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-662H/HW-D Series User's Guide