Dhcp Setup; Figure 57 Dhcp Setup - ZyXEL Communications P-662H-61 User Manual

Chapter 6 LAN Setup
Table 30 Advanced LAN Setup (continued)
LABEL
Any IP Setup
Windows
Networking
(NetBIOS over
TCP/IP)
Allow between
LAN and WAN
Back
Apply
Cancel

6.4 DHCP Setup

Use this screen to configure the DNS server information that the ZyXEL Device sends to the
DHCP client devices on the LAN.

Figure 57 DHCP Setup

108
DESCRIPTION
Select the Active check box to enable the Any IP feature. This allows a computer
to access the Internet without changing the network settings (such as IP address
and subnet mask) of the computer, even when the IP addresses of the computer
and the ZyXEL Device are not in the same subnet.
When you disable the Any IP feature, only computers with dynamic IP addresses or
static IP addresses in the same subnet as the ZyXEL Device's LAN IP address can
connect to the ZyXEL Device or access the Internet through the ZyXEL Device.
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that
enable a computer to connect to and communicate with a LAN. For some dial-up
services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
However it may sometimes be necessary to allow NetBIOS packets to pass
through to the WAN in order to find a computer on the WAN.
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
P-662H/HW-D Series User's Guide