Table of Contents
Advertisement
Post Report [5 sec]
This item appears only when the Full Screen Logo item is set to [Disabled] and allows you to
set the waiting time for the system to display the post report. Configuration options: [1 sec] [2
sec] [3 sec] [4 sec] [5 sec] [6 sec] [7 sec] [8 sec] [9 sec] [10 sec] [Until Press ESC]
2.6.3
Post Delay Time [3 sec]
Allows you to set the Post Logo Delay Time. Configuration options: [0 sec] [1 sec] ~ [10 sec].
2.6.4
Bootup NumLock State [On]
[On]
[Off]
2.6.5
Wait for 'F1' If Error [Enabled]
When this item is set to [Enabled], the system waits for the F1 key to be pressed when error
occurs. Configuration options: [Disabled] [Enabled]
2.6.6
Option ROM Messages [Force BIOS]
[Force BIOS]
[Keep Current]
2.6.7
Interrupt 19 Capture [Disabled]
[Enabled]
[Disabled]
2.6.8
CSM (Compatibility Support Module)
This option allows you to control the CSM launch parmeters.
Launch CSM [Enabled]
Configuration option: [Auto] [Enabled] [Disabled]
The following four items appear when Launch CSM is set to [Enabled].
Boot Device Control [UEFI and Legacy OpROM]
Configuration option: [UEFI and Legacy OpROM] [Legacy OpROM only] [UEFI only]
Boot from Network Devices [Legacy OpROM first]
Configuration option: [Legacy OpROM first] [UEFI driver first] [Ignore]
Boot from Storage Devices [Legacy OpROM first]
Configuration option: [Both, Legacy OpROM first] [Both, UEFI first] [Legacy OpROM
first] [UEFI driver first] [Ignore]
Boot from PCIe/PCI Expansion Devices [Legacy OpROM first]
Configuration option: [Legacy OpROM first] [UEFI driver first]
2-20
Sets the power-on state of the NumLock to [On].
Sets the power-on state of the NumLock to [Off].
The third-party ROM messages will be forced to display during the boot
sequence.
The third-party ROM messages will be displayed only if the third-party
manufacturer had set the add-on device to do so.
Enable capture of Interrupt 19 during boot process.
Disables capture of Interrupt 19 during boot process.
Chapter 2: Getting started
Advertisement
Table of Contents
