Infrared Remote Control; Irc Operation - Chauvet Gobo Shot 50W IRC User Manual

Infrared Remote
Control

IRC Operation

Note: Make sure to point the IRC directly at the receiver.
Gobo Shot™ 50W IRC User Manual
The Gobo Shot™ 50W IRC is compatible with the Infrared Remote Control (IRC) from
CHAUVET®.
The following IRC buttons are used with the Gobo Shot™ 50W IRC:
·
<BLACKOUT> - turns LED on/off
·
<STROBE> - strobing (0–20 Hz)
·
<SPEED> - gobo rotation
Note: After pressing the <SPEED> button, CU shows on the display until
you increase or decrease the gobo rotation speed (see below).
·
<%> - master dimmer
·
<MANUAL> - stops rotation
·
<FADE/SNAP> - selects clockwise/counter-clockwise
·
<+> (plus) - increases effect
- to increase gobo rotation, press the <SPEED> button first (settings 0–255)
- to increase strobing, press the <STROBE> button first (settings S000–S100)
- to increase dimming, press the <%> button first (settings L000–L255)
·
<-> (minus) - decreases effect
- to decrease gobo rotation, press the SPEED button first (settings 0–255)
- to decrease strobing, press the STROBE button first (settings S000–S100)
- to decrease dimming, press the % button first (settings L000–L255)
·
<0>–<9> - preset rotation speeds 0— 9 (slow to fast)
The buttons on the IRC not listed above are reserved for future use with
the Gobo Shot™ 50W IRC.
Page 13 of 18