Operations; Introduction Of Bluetooth Telephone Operations - Pioneer AVH-8400BT Operation Manual

Section
11 Bluetooth telephone
Introduction of Bluetooth
telephone operations
You can use Bluetooth telephone.
Telephone standby display
When switching to the entering phone
number mode
1
4
7
*
C
Important
! Since this unit is on standby to connect with
your cellular phone via Bluetooth wireless
technology, using it without the engine run-
ning can drain the battery power.
! Advanced operations that require attention
such as dialing numbers on the monitor, etc.,
are prohibited while driving. Park your vehicle
in a safe place when using these advanced

operations.

! Bluetooth connection menu cannot be se-
lected while driving.
! Operations available may be limited depend-
ing on the cellular phone connected to this
unit.
28
En
1
1
13 ARP 12:25
PM
1
Abcdefghi
1234567890123456
Auto Tone
ON OFF
8 7 6 5 4 3
13 APR 12:25
PM
1
Abcdefghi
2 3
XXXXXXXXXXXXXXXX
5 6
8 9
0 #
+ Private Vol
ON
c b a 9
! Be sure to park your vehicle in a safe place
and apply the parking brake when performing
this operation.
! If you are unable to complete the connection
using this unit, use the device to connect to
the unit.
! If you connect more than one device at a time,
connected device may not operate properly.
Connecting one device at a time is recom-
mended.
1 Incoming call notice
Indicates that an incoming call has been re-
ceived and has not been checked yet.
! Not displayed for calls made when your
cellular phone is disconnected from this
2 unit.
Touch panel keys
1
2
3
4
5
6
Display is closed.
Displaying the preset dial
screen.
Refer to Using the preset dial
lists on page 43.
Switching to the phone book
mode.
Refer to Calling a number in
the phone book on page 41.
Refer to Selecting a number
by alphabet search mode on
page 41.
Displaying the Bluetooth
connection menu.
Refer to the instructions
from page 60 to page 62.
Turning the ring tone for in-
Tone
coming calls on or off.
Refer to Switching the ring
tone on page 43.
Turning automatic answering
Auto
on or off.
Refer to Setting automatic an-
swering on page 42.